Troubleshooting guideRefrigerator repair · Free to use
Appliance Repair HubLocal technicians, one callAreas
(833) 586-3850Free for homeowners
Call now

Troubleshooting · Refrigerator repair

Refrigerator not cooling? What to check, and when to call.

A fridge that has power but has stopped getting cold is one of the most common appliance calls there is. The cause is often simple, like dusty coils or a blocked vent, and sometimes it is a failed fan or a sealed-system fault. Here is how to tell which you are dealing with.

Before you start. Unplug the fridge (or switch it off at the breaker) before you pull it out or touch anything behind the kick plate. Keep the doors shut while you work out what is wrong. The FDA recommends keeping the fridge at 40°F or below and the freezer at 0°F.

Rather not do it yourself?

  • One call, free to useTell us the make and what it’s doing.
  • Matched on zip code and brandAn independent local technician who covers your area.
  • Estimate before any workNothing gets opened up until you’ve agreed a price.
Start with a call

Likely causes

What usually causes it, most likely first.

  1. Dirty condenser coils

    The coils under or behind the fridge get rid of heat. Packed with dust and pet hair, they can’t, and the fridge runs constantly without cooling properly.

  2. Blocked air vents inside

    Cold air comes from the freezer through a vent into the fridge. A tightly packed shelf or a bag pushed against the vent starves the fresh food section.

  3. Failed evaporator fan

    If the freezer is still cold but the fridge isn’t, the fan that moves air between them may have stopped. You often hear silence where there used to be a whir.

  4. Defrost fault

    A failed defrost heater, sensor or control lets frost build over the evaporator coil until no air gets through. Thick frost on the back wall of the freezer is the tell.

  5. Condenser fan or start relay

    If the compressor clicks on and off without running, or the fan by the compressor isn’t turning, the start components or that fan are the usual suspects.

  6. Sealed-system problem

    A refrigerant leak or a failing compressor. It is the least common cause and the most expensive, which is why it is worth ruling out the others first.

Checks you can do

Safe checks before you call anyone.

  • Check the thermostat setting

    It sounds obvious, but controls get bumped. Set it to the middle or recommended setting and give it 24 hours.

  • Put a thermometer in a glass of water

    Leave it on the middle shelf overnight. It gives you a real reading to tell the technician.

  • Clean the condenser coils

    With the fridge unplugged, use a coil brush or vacuum on the coils underneath or at the back.

  • Clear the vents and check the door seals

    Move food away from the vents. Close the door on a piece of paper: if it slides out easily, that part of the seal isn’t sealing.

  • Listen at the back of the freezer

    With the door shut, a running evaporator fan makes a steady hum. No sound while the compressor is running points at the fan.

When it’s a technician job

Call a technician if:

  • It’s still warm a day after the basics

    Coils cleaned, vents clear, thermostat right and it still isn’t holding temperature.

  • Heavy frost on the freezer’s back wall

    That is a defrost system fault and needs parts.

  • Clicking, no running, or a hot compressor

    Start components and compressors need testing with the right meters.

  • You suspect a refrigerant leak

    Refrigerant work requires an EPA Section 608 certified technician by federal law.

(833) 586-3850

What affects the cost

What moves the price.

We don’t quote prices here because they depend on the fault, the model and where you live. These are the things that make the difference. Ask for the estimate before any work starts.

  • Which part has failed

    A fan motor or defrost sensor is a different job from a compressor or a refrigerant leak.

  • Built-in and high-end models

    Built-in units and some premium brands use parts that cost more and take longer to source.

  • Access

    A fridge boxed into cabinetry or on a tight floor takes longer to get to.

  • Age of the fridge

    On an older unit, a sealed-system repair can cost more than it is worth. A fair technician will tell you.

Straight answers

Common questions.

Why is my freezer cold but my fridge warm?

The fridge gets its cold air from the freezer. When the freezer is fine but the fridge is warm, the air isn’t moving between them, usually because of a failed evaporator fan, a frozen-over coil from a defrost fault, or a stuck damper.

How long is food safe if the fridge stops cooling?

With the door kept shut, a fridge holds a safe temperature for around four hours. The FDA recommends keeping the fridge at 40°F or below and the freezer at 0°F. Anything perishable that has been above 40°F for more than two hours should go.

How much will the repair cost?

Nobody can give you an honest number without seeing the machine. The technician diagnoses it, tells you the price, and only starts once you have agreed to it. If you would rather replace the appliance, you can stop there.

Who actually comes out?

An independent local technician who covers your zip code. We are a free service that connects you with them; they are not our employees and we do not guarantee their work. Ask for their license (where your state requires one) and proof of insurance before they start.

Still not working? One call.

A local technician, an arrival window and an estimate before any work starts.

(833) 586-3850
Tap to call

Call us

(833) 586-3850

Call from your phone. Thirty seconds is usually enough for us to know who to send.

Call from this computer